Caso VC8, Operating Manual

Page: 61 / 169

caso Vakuumierer VC8 61
17 Troubleshooting
This chapter provides you with important notices with regard to
operating the device. Observe the following notices to avoid
dangers and damages:
17.1 Safety notices
Attention
► Only qualified electricians, who have been trained by the
manufacturer, may carry out any repairs on electrical
equipment.
► Improperly performed repairs can cause considerable
dangers for the user and damages to the device.
17.2 Cause and Action
In the event of a fault, an error code will appear in the display; it
describes the cause of the fault.
Error Possible cause Rectification
Vacuum unit is not
functioning
Power plug is not plugged in
► Plug in mains plug!
Defective power cable or plug
► Send device to Customer
Service
Defective electrical socket
► Select another electrical
socket
The first weld on the
cut off piece of the roll
is not being carried
out.
Roll is not positioned
correctly
► Follow the steps in the
chapter “Vacuum packaging
in a bag originating on the
roll”
A complete vacuum is
not being created in
the bag.
The open end of the bag is
not completely inside the
vacuum chamber
► Position the bag correctly
The bag is defective
► Select another bag
There is dirt on the welding
and the normal seals
► Clean the seals and retry
correctly once they are dry
The bag is not being
welded correctly The welding bar is
overheating so that the bag
melts
► Open the cover on the unit
and let it cool down for a few
minutes
The bag does not hold
the vacuum after it has
been welded shut
The bag is defective
► Select another bag; wrap
paper serviettes around any
sharp edges on the content