21
H
olliston
™
DC
Switch housing and Light kit
adaptor installation:
- Continued
( LiGht kit)
Step 14g.
Connect the wires of the motor to the
wires of the light fixture. Connect the
BLue
wire from
the motor to the
BLaCk
wire of the light fixture and
connect the two
White
wires together, as shown in
Figure #15. Secure the connection using the wire
nuts.
Step 14h.
Align the two (2) posts on the light kit
assembly and the two (2) holes located on the switch
housing cap as shown in Figure #16 and insert the
posts on the light kit assembly into the two (2) holes
on the light kit adaptor plate cap as shown in Figure
#16.
Step 14h.
Locate the two (2) switch housing cap
screws as shown in Figure #17. Then attach the light
fixture to the switch housing on the bottom of the fan
as shown in Figure #17 and tighten the screws with
the provided screw driver.
Step 15i.
At this time locate and continue the
installation of the light kit by using the installation
instructions that were provided within the box with the
light kit. Once the light kit has been installed return to
the next section (WALL CONTROL PREPARATION)
of this document. You will need to install the wall
control (W-84) and learn how to operate the fan and
light on the Holliston fan.
Figure #15
WiRe nut
SWitCh houSinG
LiGht FixtuRe
{example Photo}
BLaCk and White
WiReS
Figure #17
BLue and
White WiReS
LiGht FixtuRe
{example Photo}
Figure #16
tWo (2)
SCReWS
hoLeS
tWo (2)
PoSt
tWo (2)
SCReW
hoLeS
Switch housing
Cap Screw (2)
8-32 x 3/8
Switch housing
Cap Screw (2)
8-32 x 3/8
