18
SwItcH HoUSInG and end cap InStallatIon
SWitCh houSinG haRdWaRe
(not to scale)
Light kit
adaptor assembly
SCReW PLuG
SCReW
#6-32
BottoM CaP
LiGht kit
adaPtoR
SCReW
#6-32
CaP
Step 13a.
Locate the light kit adaptor assembly and
screw plug as shown in the switch housing hardware
section above. You will need to disassemble and use
parts from the light kit adaptor assembly for adding a
light kit to your fan.
.
Light kit adaptor disassembly
Step 13b.
Locate and remove the #6-32 screw that
is attaching the bottom cap to the light kit adaptor
assembly as shown in Figure #3 and remove
the bottom cap. Do not discard screws during
disassembly.
Step 13c.
Locate and remove the four (4) #6-32
screws from the cap as shown in Figure #4 and
remove the cap. Do not discard screws during
disassembly.
Figure #3
Figure #4
Figure #5
BottoM CaP
SCReW , #8-32
BottoM CaP
LiGht kit
adaPtoR
Cap SCReW,
#6-32
(Screws 4)
CaP
NOTE:
locate .the .light .kit .adaptor .as .shown .in .Figure .
#5, .this .adaptor .plate .will .need .to .be .attached .to .the .fan .
during .fan .installation, .installation .instructions .continued .
on .the .next .page .of .this .document .
Figure #1
Figure #2
LiGht kit
- Installation:
NOTE: If you are installing your fan with a light kit
attached as below in Figure #1, continue with these
installation instruction Step 13a. Also you will need the
installation instructions that came with your new light
kit to complete the installation of the fan.
Switch housing
Cap
Switch housing
Cap Screw (2)
8-32 x 3/8
do not discard screws during disassembly,
all screws will be needed for other installation
steps within this document.
.
