14
Switch Housing Installation
Step 12a.
Place the switch housing gasket against
the adapter plate and partially install two of the three
switch housing screws onto the switch housing
adapter plate as shown in Figure #1.
Step 12b.
Thread the Molex Plug through the hole
in the center of the switch housing and align the two
keyholes with the two screws that were installed on
the switch housing adapter plate. Place the switch
housing over the two screws and rotate it clockwise
so that the two screws are holding the switch housing
as shown in Figures #2 and #3.
Step 12c.
Align the screw hole on the switch housing
with the screw hole in the switch housing plate and
insert the third screw as shown in Figure #3. Then
tighten all three screws with the provided screwdriver.
SWITCH HOUSING AND END CAP INSTALLATION
SWITCH HOUSING HARDWARE
(not to scale)
Switch Housing
Adapter Plate
Adapter Plate
Screws (4)
Cover Plate Cap
Cover Plate
Screw (1)
Figure #1
Figure #2
Figure #3
SWITCH
HOUSING
SCREWS
SWITCH
HOUSING
SCREWS
Switch Housing
Gasket
Phillips
Screwdriver
Cap Plug
Light Kit
Screws (3) Light Kit Pull Chain (1)
Fandangle (3)
Light Kit Gasket
Switch Housing
Screws (3)
SWITCH
HOUSING
GASKET
