CI-100A Indicator Operation & Service Manual
────────────────────────────────────────────────────────
CAS-USA
Corporation
www.cas-usa.com
16
UPCTWT
YES
NO
Yes/No=enable/disable output weight of 1%
percentage. Prompt is “1% REF WT”
NO
COUNT YES
NO
Yes/No=enable/disable output counts. Prompt is
“QUANTITY”
NO
PCWT YES
NO
Yes/No=enable/disable output piece weight.
Prompt is “PIECE WT”
NO
BMI YES
NO
Yes/No=enable/disable output height and BMI.
Prompt is “HEIGHT” and “BMI”
NO
ACCUMU YES
NO
Yes/No=enable/disable output accumulation
times and total. Prompt is “ACC. N” and
“TOTAL”
NO
DATE YES
NO
Yes/No=enable/disable output date. Prompt is
“DATE”
NO
TIME
YES
NO
Yes/No=enable/disable output time. Prompt is
“TIME”
NO
AD.CODE
YES
NO
Yes/No=enable/disable output ADC's code.
Prompt is “A/D CODE”
NO
BAT.VOL YES
NO
Yes/No=enable/disable output voltage of
battery. Prompt is “VOLTAGE”
NO
STATUS YES
NO
Yes/No=enable/disable output scale's status.
Prompt is “STATUS”
NO
B.LINE NONE
LINE1
How many blank lines after strings output:
NONE=no blank line, LINE1/2/3/4=there're 1,
2,3 or 4 blank lines after strings, used for
paper feed forward 1/2/3/4 lines.
LINE1
LINE2
LINE3
LINE4
BEEP KEY YES
YES
Yes/No=enable/disable beep after a key
pressed down
NO
COMPAR
NONE
IN.LMT
(1)NONE=not beep; (2)L.Low=beep when lower
than low limitation; (3)IN.LMT=beep when in
range of low and high limitation;
(4)O.HIGH=beep when over high limitation;
(5)OUT.LMT=beep when lower than low
limitation or higher than high limitation
L.LOW
IN.LMT
O.HIGH
OUT.LMT
HOLD HLD.MOD
NONE
AUTO
HOLD Mode: (1)NONE=no hold function
(2)PS.PEAK=Positive Peak number Hold mode:
scale will display and refresh the positive peak
value from last zero setting
(3)NG.PEAK=Negative PEAK number Hold
mode. it's Similar with PS.PEAK, but negative
number is used. (4)TOGGLE=Press HOLD key
to enter HOLD mode, if weight is over
(NLD.RNG) and stable, the data will be frozen
until press HOLD key again to exit. (5)
AVERAG= Average HOLD mode: in this
mode, if weight is over (NLD.RNG), and its
variation is less than (HLD.RNG), the average
data in (AVG.TIM) will be frozen. Press HOLD
key or (HLD.TIM) time elapsed to exit this
mode (6)AUTO=Auto hold mode: it's similar with
PS.PEAK
NG.PEAK
TOGGLE
AVERAG