CI-100A Indicator Operation & Service Manual
────────────────────────────────────────────────────────
CAS-USA
Corporation
www.cas-usa.com
24
5.13
Check Weight
in weighing mode:
5.13.1 To make weight compare function be available,
CONFIG-FUNC-COMPAR
item should set to
YES
,
and high and low limitation of weight should be set correctly according to following steps:
5.13.2
In weighing mode, Press down
DATA
key more than 3s to input compare data of high and low.
5.13.3 After
HIGH
being shown, 000000 will be displayed, use
,
ACC
,
UNIT
key to input high weight
number and press
TARE
key to confirm. Annunciator of
Hi
will be shown in this step. Press
ZERO
key to exit and back to weighing mode.
5.13.4 After
Low
being shown, 000000 will be displayed, use
,
ACC
,
UNIT
key to input low weight
number and press
TARE
key to confirm. Annunciator of
Lo
will be shown in this step. Press
ZERO
key to exit and back to weighing mode.
NOTE:
If High number is 0 or is equal or less than low number, the comparison will be disabled, and the
input data has no limitation.
5.13.5
After a reasonable limitation is set and compare is be active, one of annunciator
HI, OK, LO
will be
lighted, and the beeper will sound according to its setting in
USER-BEEP
.
5.14
Enter Setup Mode
:
5.14.1
If need to set configuration parameters, set user parameters, calibrate the scale, set current date or
time, test some hardware… It’s need to long press
SETUP
key to enter setup mode
5.14.2
After Entering Setup Mode, the main menu item
CONFIG
will be shown first.
5.14.3
In Setup mode, use to select wanted submenu and
wanted menu item, select wanted choice, set wanted number, confirm and save data, or exit this
mode. Please refer the
“4.Operation Menu Structure”
.
6. Count Weighing Mode
6.1
In this mode, scale will weigh goods weight on scale, calculate and display its counts after the piece
weight of goods is obtained
6.2
To make counting function be available,
CONFIG-FUNC-COUNT
item should be set to
YES
in
CONFIG
menu.
6.3
To enter counting working mode, in normal weighing or percent-weighing mode, long press
FUNC
key,
WEIGH/PERCEN
will be shown, use
ACC
or
key to select
COUNT
, then press
TARE
to
confirm go to parts counting mode. Before new piece weight is got, the last piece weight will be
used.
6.4
In counting working mode, the function of
ZERO, TARE, PRINT, HOLD, PRESET TARE, ACC,
SETUP, ON/OFF
are available.
6.5
There’re two ways to obtain the piece weight: (1) input piece weight directly, refer operations of
step6.5.1 (2)weigh samples weight which quantity is known, refer operation of step 6.5.2
6.5.1
Input piece weight from keypad: in counting mode, press
UNIT
key, When
InP.PWt
is shown, press
