Carver 396 Motor Yacht 2003, Owner'S Manual

Page: 73 / 234

S
ECTION
3 AC E
LECTRICAL
S
YSTEM
61
3808 4/99
Before starting the generator, operate the bilge
blowers for at least 4 minutes, then inspect the bilge
for fuel vapor. If you detect fuel vapor in the bilge, do
not start the generator. Identify and correct the
source of the vapor, then operate the bilge blowers
for at least 4 more minutes before starting the gen-
erator. Continue to operate the bilge blowers while
the generator is running.
The generator STOP/START switch is spring acti-
vated. Release the switch from its "START" position
as soon as the generator starts. If you continue to
hold the switch in its "START" position after the
generator starts, you may damage the starter.
While you are attempting to start the generator,
never hold the STOP/START switch in the "START"
position for more than 10 seconds.
6. A spring-loaded generator STOP/START switch is
located at the top left of the DC Control Center.
Push the switch to the "START" position and hold it
there until the generator starts. Release the switch
when the generator starts.
If the generator does not start within 10 seconds,
release the STOP/START switch, wait 1 minute,
then try to start the generator again.
7. When the generator is running smoothly, switch
the upper and lower (if your boat has the optional
air conditioning system) Generator circuit breaker
groups on the AC Control Center "ON". This con-
nects the generator to the boat’s AC electrical
system. AC receptacles and accessories can now be
used in the same manner as when the boat is
connected to a shore power source.
8. To turn the generator "OFF", push the STOP/
START switch to the "STOP" position. If you do not
intend to use the generator again for at least a few
days, place the generator battery master disconnect
switch in the "OFF" position.