Carver 396 Motor Yacht 2003, Owner'S Manual

Page: 117 / 234

S
ECTION
4 I
NTERNAL
S
YSTEMS
105
3808 4/99
flue pipes, at least annually, and replace them if any
deterioration, cracks or openings are found.
Never use flame to check your propane stove system
for leaks.
The propane stove system is inspected and pressure
checked as part of Carver’s quality assurance process.
We do, however, suggest that you test the system for
leaks regularly. Use the following system inspection
process every time you remove and reinstall the pro-
pane tank. The following information has been taken
from the Seaward Products Owner’s Manual For Gas-
Operated Stoves.
1. After the propane tank has been installed, the
regulator system connected, the hose run and
connected to both the stove and regulator, slowly
open the propane tank valve until the propane is
flowing. The pressure gauge on the regulation
system should read approximately 110 psi at 70
degrees F. (the pressure is higher if the air around
you is warmer; lower if the air is cooler).
2. Close the propane tank valve and observe the
pressure gauge. It should hold a constant reading
over a 15-minute period. If the gauge reading
decreases over that time, there is a leak in the
system.
If a leak is present:
1. Make sure the propane tank valve is closed.
Do not use soap that contains ammonia.
2. Use a soap and water solution to check all propane
fittings. The solution forms bubbles where propane
is leaking from the system.
If you cannot find the leak, contact SeaWard Prod-
ucts or your Carver Dealer.
Checking the
System For Leaks