Carson Dragster Sport, Instruction Manual, Page: 38 / 100

GB
38 CARSON DRAGSTER Brushless Controller
13. Selecting a Pre-programmed driver Profiles
(Throttle/Brake
Settings)
Profiles 1 - 4 have no influence on the undervoltage protection set at the
time when you selected the type of battery.
Driver profile 1 2 3 4 reset to
factory
defaults
5
Cut-Off as
selected
as
selected
as
selected
as
selected
NiMH
Reverse travel no yes yes no yes
Percentage
reverse travel 0 50 50 0 25
Maximum
braking
performance 30% 30% 40% 40% 30%
Parking brake 15% 10% 15% - 10%
Dead Band 3 3 4 4 3
• Press the SET button down until all of the LEDs light up. Release the SET
button again.
• All LEDs start flashing. This shows that you are in the mode for setting
the driver profile.
• Press the SET button repeatedly until you reach the required setting. All
LEDs flash at the next highest speed.
• By repeatedly pressing briefly on the SET button you can scroll through
the settings.
• When you reach the required setting, hold down the SET button for
approx. 2 seconds; the setting is stored.
• Once you have stored the setting, the status LEDs flash one after
the other to show that you are leaving the programming mode. The
controller is ready for operation again.
• If you do not press the SET button for more than 10 seconds the
controller reverts to the last setting and is ready for use again.