Carson Dragster Sport, Instruction Manual, Page: 33 / 100

GB
33 CARSON DRAGSTER Brushless Controller
When the battery type is selected, the undervoltage protection (NiCd/
NiMH: at 4 V or lower, two or three-cell LiPo: at 3.0 V per cell or lower) is
activated.
If you wish to drive without undervoltage protection (Cut-Off), you must
select 5 in the driver profile (reset to factory defaults) and reconfigure the
other parameters to your requirements again.
Flashing
frequency 1 2 3
Battery type NiCd/NiMH LiPo
(2 cells)
LiPo
(3 cells)
• Switch on the transmitter, then the controller!
• Press the SET button down until the red LED lights up. Release the SET
button.
• The red LED starts flashing. This shows that you are in the mode for
setting the battery type.
• Press the SET button again briefly. This brings you to the next setting.
The red LED flashes at the next highest speed.
• By repeatedly pressing briefly on the SET button you can scroll through
the settings.
• When you reach the required setting, hold down the SET button for
approx. 2 seconds; the setting is stored.
• Once you have stored the setting, the status LEDs flash one after
the other to show that you are leaving the programming mode. The
controller is ready for operation again.
• If you do not press the
SET button for more than
10 seconds the controller
reverts to the last setting
and is ready for use again.
8. Selecting the Battery Type