Carson Dragster Sport, Instruction Manual, Page: 37 / 100

GB
37 CARSON DRAGSTER Brushless Controller
With the dead band setting you can adjust the speed controller to the
transmitter being used by changing the transition from forward drive to
brake action. Level 1 means a narrower transition area which requires
particularly finely tuned transmitting signals. Simple transmitters are
sufficient for the wider transition area at Level 5.
Flashing
frequency 1 2 3 4 5
Dead Band (%) 2 3 4 5 6
• Press the SET button down until the blue and red LEDs light up.
Release the SET button again.
• The blue and red LEDs start flashing. This shows that you are in the
mode for setting the dead band delay time.
• Press the SET button repeatedly until you reach the required setting.
The blue and red LEDs flash at the next highest speed.
• By repeatedly pressing briefly on the SET button you can scroll through
the settings.
• When you reach the required setting, hold down the SET button for
approx. 2 seconds; the setting is stored.
• Once you have stored the setting, the status LEDs flash one after
the other to show that you are leaving the programming mode. The
controller is ready for operation again.
• If you do not press the SET button for more than 10 seconds the
controller reverts to the last setting and is ready for use again.
12. Setting the Dead Band