Carson Dragster Sport, Instruction Manual, Page: 35 / 100

GB
35 CARSON DRAGSTER Brushless Controller
• Press the SET button down until the blue and green LEDs light up.
Release the SET button again.
• The blue and green LEDs start flashing. This shows that you are in the
mode for setting maximum brake performance.
• Press the SET button repeatedly until you reach the required setting.
The blue and green LEDs flash at the next highest speed.
• By repeatedly pressing briefly on the SET button you can scroll through
the settings.
• When you reach the required setting, hold down the SET button for
approx. 2 seconds; the setting is stored.
• Once you have stored the setting, the status LEDs flash one after
the other to show that you are leaving the programming mode. The
controller is ready for operation again.
• If you do not press the SET button for more than 10 seconds the
controller reverts to the last setting and is ready for use again.
Flashing
frequency 1 2 3 4 5 6 7 8 9 10
Brake
performance
(%) 10 20 30 40 45 50 55 60 65 70
10. Setting the Maximum Brake Performance