38
CARSON DRAGSTER Brushless-Regler
GB
When the battery type is selected, the undervoltage protection (NiCd/NiMH: at 4
V or lower, two or three-cell LiPo: at 3.0 V per cell or lower) is activated.
If you wish to drive without undervoltage protection (Cut-Off), you must select 5
in the driver profile (reset to factory defaults) and reconfigure the other parameters
to your requirements again.
Flashing
frequency
1
2
3
Battery type
NiCd/NiMH
LiPo
(2 cells)
LiPo
(3 cells)
•
Switch on the transmitter, then the controller!
•
Hold down the SET button until the blue LED flashes. Release the SET button
again. You are in the battery type selection facility.
•
Press the SET button again briefly. This brings you to the next setting.
The red LED flashes at the next highest speed.
•
By repeatedly pressing briefly on the SET button you can scroll through the
settings.
•
When you reach the required setting, hold down the SET button for approx. 2
seconds; the setting is stored.
•
When you have saved the setting, the red and blue LED‘s flash alternately 3x in
order to indicate that you have exited programming mode. Switch controller
off and on again to activate the selected settings.
•
If you do not press the SET button for more than 10 seconds the controller
reverts to the last setting and is ready for use again.
8. Selecting the Battery Type
Set-button
ON
OFF
