40
CARSON DRAGSTER Brushless-Regler
GB
•
Press the SET button down until the blue LED light up 3 times. Release the SET
button again.
•
The red LED start flashing. This shows that you are in the mode for setting
maximum brake performance.
•
Press the SET button repeatedly until you reach the required setting.
The red LED flash at the next highest speed.
•
By repeatedly pressing briefly on the SET button you can scroll through the
settings.
•
When you reach the required setting, hold down the SET button for approx.
2 seconds; the setting is stored.
•
Once you have stored the setting, the red and blue LEDs flashes alternate 3
times to show that you are leaving the programming mode. Switch controller
off and on again to activate the selected settings.
•
If you do not press the SET button for more than 10 seconds the
controller reverts to the last setting and is ready for use again.
Flashing
frequency
1
2
3
4
5
6
7
8
9
10
Initial brake
performance
(%)
10
20
30
40
45
50
55
60
65
70
10. Setting the Initial Brake Performance
Blue LED
Red LED
