43
CARSON DRAGSTER Brushless-Regler
GB
13. Selecting a Pre-programmed driver Profiles
(Throttle/Brake
Settings)
Profiles 1 - 4 have no influence on the undervoltage protection set at the time
when you selected the type of battery.
Driver profile
1
2
3
4
reset to
factory
defaults
5
Cut-Off
as
selected
as
selected
as
selected
as
selected
NiMH
Reverse travel
no
yes
yes
no
yes
Percentage
reverse travel
0
50
50
0
25
Initial braking
performance
30 %
30 %
40 %
40 %
30 %
Parking brake
15 %
10 %
15 %
-
10 %
Dead Band
3
3
4
4
3
•
Press the SET button down until the blue LEDs light up 6 times. Release the
SET button again.
•
The red LED start flashing. This shows that you are in the mode for setting the
driver profile.
•
Press the SET button repeatedly until you reach the required setting. The red
LED flash at the next highest speed.
•
By repeatedly pressing briefly on the SET button you can scroll through the
settings.
•
When you reach the required setting, hold down the SET button for approx. 2
seconds; the setting is stored.
•
Once you have stored the setting, the red and blue LEDs flashes alternate 3
times to show that you are leaving the programming mode. Switch controller
off and on again to activate the selected settings.
•
If you do not press the SET button for more than 10 seconds the
controller reverts to the last setting and is ready for use again.
