Carrier XtendFRESH, Operation, Service And Parts Manual

Page: 34 / 72

T-366 6–10
Figure 6.14 Carbon Filter with Gasket and Seal Plate
10.Place the top plate and gasket on the top of the filter. Align the top housing so that the gasket and aluminum
plate fit into the recess in the housing.
11. Bolt the housing together with the bolt and spring assemblies ( Figure 6.12 ).
12.When tightening the spring assemblies the spring gap must be 0.310 inches (8mm) between the bottom of
the washer and the housing tab surface ( Figure 6.15 ).
Figure 6.15 Bolt/Spring Assembly Dimension
6.7.2 Installing the Scrubber
1. Align the scrubber shaft in the slot of the coupling attached to the motor.
NOTICE
It will aid in the installation if the shaft coupling (on top of the shaft) is loose to help with self-
alignment. It will tighten during motor rotation.
2. The scrubber requires a ten degree turn in order to secure the back portion into the mounting tabs ( Figure
6.16 ).
Gasket
Carbon Filter
Orientation
Mark
Seal Plate
0.310in 8mm
Recommended Gauge:
Part # 48-00504-00