Carrier XtendFRESH, Operation, Service And Parts Manual

Page: 35 / 72

6–11 T-366
Figure 6.16 Scrubber Housing
3. Connect the hoses from the air ducts to the scrubber housing ( Figure 6.10 ).
4. Make sure the hose is completely on the housing, tighten the hose clamps and use cable ties to secure the
hoses to the gusset. Be sure the hoses are level.
5. Reconnect the scrubber heaters. Use cable ties to secure the wiring to prevent chafing.
6.7.3 Replacing the Scrubber Motor
When replacing the Scrubber motor it can be accessed through the inside of the container. Refer to Figure 6.10 for
the physical location of the motor.
1. Start by removing the scrubber housing. Refer to Section 6.7.1
2. After removing the scrubber housing remove the four 1/4-20 mounting screws that attach the scrubber
mounting plate to the fan deck ( Figure 6.17 ).
Figure 6.17 Scrubber Mounting Plate
3. Carefully lower the plate while unplugging the scrubber motor connection. It may be necessary to cut the wire ties.
4. Remove the four hex head screws holding the motor to the mounting plate ( Figure 6.18 ).
4 Mounting Screws