Carrier XtendFRESH, Operation, Service And Parts Manual

Page: 33 / 72

6–9 T-366
Figure 6.12 Scrubber Bolt/Spring Assemblies
7. Separate the upper and lower halves of the scrubber housing.
8. Remove the carbon filter for the scrubber housing along with the gaskets and aluminum seal plate ( Figure
6.13 ).
Figure 6.13 Scrubber Separated with Filter
9. Install the seal plates and gaskets. Replace if damaged. Reinstall the new filter, making sure the gasket and
seal plate are in the proper position. The side of the seal plate with the X must be installed towards the gas-
ket (
Figure 6.14 ).
Bolt and Spring
Assembly (4)
Carbon Filter with
Gaskets and
Aluminum Seal Plate