Carrier UC Open XP, Installation And Startup Manual, Page: 12 / 44

UC Open XP installation
8 UC Open XP/UC Open XP IO
To install the UC Open XP:
1
Mount the controller. (page 9)
2
Wire the controller for power. (page 10)
3
Set the controller's address. (page 10)
4
Wire expanders to the controller. (page 18)
5
Wire inputs and outputs (page 13).
6
Wire sensors to the controller. (page 23)
To install the UC Open XP into an i-Vu Open Control System
You must complete the following procedures to successfully install your UC Open XP into an i-Vu Open Control
System. Use the Help in the referenced software for detailed descriptions of these procedures.
ApplicationBuilder or Snap
1
Use ApplicationBuilder or Snap to create control program(s) for your UC Open XP.
2
If applicable, print the Sequence of Operation created by ApplicationBuilder, which includes the points
list.
NOTE You can create a points list under Reports in Field Assistant after installing your control program.
UC Open XP Installation Guide
1
Prepare a wire list using the points list. Refer to the Appendix (page 29).
2
Use the wire list and the following installation procedures to install and wire I/O points to your UC Open
XP and expander, if applicable.
i-Vu/Field Assistant
1
Complete the Discovery process to upload the controller to the database.
2
In Discovery > Setup , select Add Control Program , upload control program and graphic to i-Vu/FA, then
download to the controller.
3
Select the controller in the navigation tree and go to Properties page > I/O Points tab to assign channel
numbers to the physical points.
NOTE 39m AHU Equipment has pre-assigned IO channels. See Appendix B (page 33). You must assign
IO channels in all other applications by:
○
Entering your channel numbers under Num , using your wire list
○
Entering your expander address under Exp , if applicable
○
Selecting the appropriate value under Sensor/Actuator Type , if applicable
UC Open XP installation