Appendix C: RTU Open Points/Properties on the Equipment Touch
RTU Open v3
CARRIER CORPORATION ©2019
Installation and Start-up Guide
All rights reserved
97
Point Name/Description
Range
Input 8 Function
– The usage of Input 8. You must also set
Input 8 Switch
Configuration
.
Options:
No Function
– The input is not used.
Enthalpy Switch
– Indicates enthalpy status (high or low).
Fan Status
– Proves supply fan operation.
Filter Status
– Indicates a dirty filter.
Remote Occupancy
– Sets occupancy using a hardware contact.
Door Contact
– Sets occupancy using a hardware contact.
D:
R:
Enthalpy Switch
No Function
Enthalpy Switch
Fan Status
Filter Status
Remote Occupancy
Door Contact
Input 9 Function
– The usage of Input 9. You must also set
Input 9 Switch
Configuration
.
Options:
No Function
– The input is not used.
Humidistat
– Indicates high humidity condition.
Fan Status
– Proves supply fan operation.
Filter Status
– Indicates a dirty filter.
Remote Occupancy
– Sets occupancy using a hardware contact.
Door Contact
– Sets occupancy using a hardware contact.
IGC Override
– Monitors the flame output from the Integrated Gas Control board. The
input detects if a flame is still present after heating has been disabled.
D:
R:
Humidistat
No Function
Humidistat
Fan Status
Filter Status
Remote Occupancy
Door Contact
IGC Override
Status - Equipment Touch
Navigation:
Equipment Touch:
Status
Point Name/Description
Range
Equipment Status
– The controller's current status.
R: Disabled
Test
Run
System Mode
– The controller's current operating mode.
R: Off
Fan Only
Economizer Cooling
Cooling
Heating
Dehumidification
Test
Shutdown
Unocc Free Cooling
Fire Shutdown
IAQ Override
Pre-occ Purge
Supply Fan Status
– The current fan status if an input is configured for
Fan Status
.
R: Off/Running
Fan / Speed –
The current commanded fan speed if
Fan Control
is set to
Two Speed
.
R: Off/Low/High
Summary of Contents for RTU Open v3
Page 113: ......