![background image](http://html1.mh-extra.com/html/carrier/rtu-open-v3/rtu-open-v3_installation-and-startup-manual_2562508048.webp)
Sequence of Operation
RTU Open v3
CARRIER CORPORATION ©2019
Installation and Start-up Guide
All rights reserved
44
The RTU Open supports various types of constant volume air source configurations:
•
Standard heat/cool unit types with up to 2-stages of mechanical cooling and gas or electric heating
•
Heat pump units utilizing a reversing valve output for heating and cooling control
•
Heat pump unit (Carrier) with an OEM defrost control board
•
Economizer, CO2, Demand Limiting, and RH control strategies are available for appropriately equipped units
•
LC WeatherExpert™ unit with 3-stage compressor control and variable speed supply fan control.
The RTU Open may operate as part of a VVT system using Airside Linkage or as a stand-alone controller.
Occupancy
The RTU Open’s operation depends upon its occupancy state (
Occupied
/
Unoccupied
). The RTU Open operates
continuously in the
Occupied
mode until you configure an occupancy schedule.
An occupancy schedule may be:
•
A local schedule configured in the controller using an Equipment Touch or Field Assistant
•
A BACnet schedule configured in the i-Vu® application, networked through an i-Vu® Open Router
•
A BACnet or local schedule configured for subordinate VVT Zones, networked through an i-Vu® Open
Router(s) and employing Linkage
To set up occupancy schedules, see the documentation for your user interface.
NOTE
A BACnet schedule, downloaded from the i-Vu® application will overwrite a local schedule that was set up
with an Equipment Touch or Field Assistant.
Occupancy Source
- the following settings determine occupancy.
Options:
•
Always Occupied
– (default) Controller operates continuously, regardless of any configured schedule
•
BACnet Schedule
– Uses a local BACnet occupancy schedule configured within the controller
•
BAS On/Off
– Occupancy is set over the network by another device or a third party BAS. Refer to the
RTU
Open Integration Guide
for additional instructions in communication protocols.
•
Remote Occ Input
– Controller monitors an input contact connected to one of the available binary inputs
configured to receive it. You must set
Unit Configuration
>
Occupancy Source
to
Remote Occ Input
and one
Input Switch Configuration
to
Remote Occupancy
.
Sequence of Operation
Summary of Contents for RTU Open v3
Page 113: ......