27
• Drain hose and drain cap are assembled as shown in figure 9 in the factory. To do right-side(
), right-botton(
) or right-back(
) piping in figure 3, draw
the drain hose to right-side piping direction.(It is not necessary to exchange the location of drain hose and drain cap.)
• Tie the refrigerant pipe, the drain hose, and the electrical connection cord together.
• Form the refrigerant piping in the required direction, and bind the drain hose and the electrical connection cord together with vinyl tape.
The drain hose should be at the bottom. ( Figure. 10 )
• Pass the pipes through the wall sleeve and then hook the indoor unit body onto the top of the wall hang bracket. ( Figure. 12 )
• For Left Piping, hang the unit onto the top of the wall hang bracket and incline the unit using a tool such as a screw
-driver set between the middle area of body and bottom right of the wall hang bracket. Connecting the pipe can be done more easily if the unit is inclined.
• Snap the marking places of the body(A, B) onto the hole of the bracket.
1234567890123456789012345678901212345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234
1234567890123456789012345678901212345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234
1234567890123456789012345678901212345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234
1234567890123456789012345678901212345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234
1234567890123456789012345678901212345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234
4) Forming the Drain Hose and Refrigerant Piping
1234567890123456789012345678901212345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234
1234567890123456789012345678901212345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234
1234567890123456789012345678901212345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234
1234567890123456789012345678901212345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234
1234567890123456789012345678901212345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234
5) Installing the Indoor Unit Body to the Wall Hang Bracket
INDOOR UNIT INSTALLATION
• For Left Piping, fit the pipes and the wiring into the recess at the back of the unit as shown in Figure 11.
Figure 10
Figure 9
Figure 11
Indoor unit piping
Connection cord
Drain hose
Drain cap
Drain hose
42KH5A54020_I
2004.6.11, 3:15 PM
Page 27
Adobe PageMaker 6.5K/PPC