24
INDOOR UNIT INSTALLATION
• The piping can be connected to the four directions indicated by
,
,
,
.
When the piping is connected to the direction of
,
or
, detach the knock-
out either at the side or at the bottom of the unit. ( Fig. 3 )
12345678901234567890123456789012123456789012345678901234567890121234
12345678901234567890123456789012123456789012345678901234567890121234
12345678901234567890123456789012123456789012345678901234567890121234
12345678901234567890123456789012123456789012345678901234567890121234
12345678901234567890123456789012123456789012345678901234567890121234
1) Installing the Wall Hang Bracket
• Install the wall hang bracket so that it is level. Use a plumb line if necessary.
( Figure. 4 )
• Be sure to leave the clearance spaces shown in Figure 1.
• Before installing the wall hang bracket, remove it from the unit by pushing up
marks ( ) at the bottom of the body.
• Fasten the wall hang bracket to the wall with 5 or more self-tapping screws
through the holes near the outer edge of the bracket as shown in Figure 4.
• Install the wall hang bracket so that there is no gap between the bracket and the wall.
• Check that the wall hang bracket does not move to prevent noise during
operation.
Figure 3
Figure 4
30cm
or more
10cm
or more
45cm
or more
PLUMB
REMOVE SCREW
NOTE
• In case of removing the unit from the wall hang bracket after installing it
onto the wall, remove by pushing up MARKS ( ) at the bottom of
the body.
42KH5A54020_I
2004.6.11, 3:15 PM
Page 24
Adobe PageMaker 6.5K/PPC