VVT Zone Controller
13
Voltage
300 Vac, power limited
Listing
UL: NEC CL2P, or better
To wire the SPT sensor to the controller
1
Partially cut, then bend and pull off the outer jacket of the Rnet cable(s). Do not nick the inner insulation.
Strip about .25 inch (.6 cm) of the inner insulation from each wire.
Outer Jacket
Inner insulation
.25 in.
(.6 cm)
2
Wire each terminal on the sensor to the same terminal on the controller. See diagram below.
NOTE
Carrier recommends that you use the following Rnet wiring scheme:
Connect this wire...
Red
To this terminal...
Black
White
Green
+12V
Rnet-
Rnet+
Gnd
3
Verify that the
Rnet
jumper is set to
Rnet
.
Summary of Contents for OPN-VVTZC
Page 2: ......
Page 27: ...VVT Zone Controller 23 Single duct 2 position hot water Single duct modulating hot water...
Page 79: ......