Addressing the controller
Chilled Water System Optimizer v2
CARRIER CORPORATION ©2019
Installation and Start-up Guide
12
All rights reserved
Parity
None
Flow Control
None
7
Click
Open
. A window similar to the one below appears.
8
Do one of the following:
○
To change a property value:
a. Type the number of the property, then press
Enter
.
b. Type the new value, then press
Enter
.
○
To take an action, type number of the action, then press
Enter
.
9
If you changed a value, type
1
, then press
Enter
to restart the controller.
10
Close PuTTY.
11
Verify that you can communicate with the controller by issuing a PING command to the IP address specified in
step 12.
NOTE
Your computer must be on the same subnet as the controller for the PING command to work.
12
When finished, set the controller's
Router Config
Mode
DIP switch to
OFF
to restore normal functionality to
the Local Access port.
13
Cycle the controller's power to accept the
Router Config Mode
changes.