Addressing the controller
Chilled Water System Optimizer v2
CARRIER CORPORATION ©2019
Installation and Start-up Guide
9
All rights reserved
To address the controller for third-party integration, in the i-Vu® interface, go to
Driver Properties
>
Protocols
>
Properties
tab. Refer to the appropriate protocol
Integration Guide
for further details.
The controller needs...
That is unique
on the...
Notes
An IP address
IP Network
Set the
IP Addr
DIP switch to choose one of the following:
DHCP —
to obtain an IP address from a DHCP server
If there is no DHCP server, the following are the default
IP settings:
○
192.168.168.xx, where xx = rotary address
○
subnet mask = 255.255.255.0
○
default gateway = 192.168.168.254
Assigned
— a
custom
IP address
NOTE
The controller address is also used to
autogenerate the BACnet device instance/name for the
router. See Configuring BACnet device instance and
network number.
To set the controller address on the Open network
CAUTION
The controller address must be unique on the IP and Open network.
1
If wired for power, turn off the power.
NOTE
The controller only reads the rotary switch positions during power up or upon reset.
2
Use the rotary switches to set the address. Set the
Tens
(
10's
) switch to the tens digit of the address, and set
the
Ones
(
1's
) switch to the ones digit. Valid addresses are 1 - 99.
EXAMPLE
If the controller’s address is 25, point the arrow on the
Tens
(
10's
) switch to 2 and the arrow on
the
Ones
(
1's
) switch to 5.
10's
1's
1
3
45
2
7
8
9
6
0
1
3
45
2
7
8
9
6
0
3
Turn on the controller's power.
CAUTION
The factory default setting is
00
and must be changed to successfully install your controller.
Addressing the controller