– 10 –
19-EN
20-EN
EN
FR
Adjustment of wind direction
For best cooling performance, adjust the louvers
(adjustment plates of up / down wind direction)
appropriately. Cold air descends and warm air rises,
so to cool a room tilt them horizontally.
CAUTION
Direct the louvers horizontally for cooling.
If the louvers stay pointed downward during cooling,
condensation may form on the discharge port and / then
drops from the louvers.
When operation is stopped, the horizontal louver
(plate for adjusting the vertical air flow) automatically
closes.
How to set up the wind direction
Push
during operation.
The wind direction changes for every push of the
button.
How to start swinging
Push
, set the louver (adjustment plate
of up / down wind direction) direction to the
lowest position, and then push
again.
SWING
is displayed and the up / down wind
direction is automatically selected.
Display during swinging
How to stop swinging
Push
at a desired position while the
louver is swinging.
When
is pushed after that, wind direction
can be set again from the highest position.
* However, even if
is pushed while the louver
is swinging, the louver position is displayed as
follows and highest position of the louver may not
be selected.
Display when swinging is stopped
In this case, push
again two seconds later.
In Cool / Dry operation, the louver does not stop
as it directs downward. If stopping the louver as
it directs downward during swing operation, it
stops after moving to the third position from the
highest position.
Display when stopping the swing
Unit select button
When multiple indoor units are controlled with one
remote controller, wind direction can be set for each
indoor unit by selecting individually.
To set wind direction individually, push
button (left side of the button) to display an indoor
unit number in the control group. Then set the wind
direction of the displayed indoor unit.
When no indoor unit number is displayed, all indoor
units in the control group can be controlled
simultaneously.
Each time
button (left side of the button) is
pushed, the display changes as follows:
Horizontal air flow adjustment
To change the horizontal air flow direction, point the
vertical louvers inside the horizontal louver in your
preferred direction.
NOTE
When the horizontal louver is pointing downward in
COOL mode, water droplets may form on the surface
of the cabinet or louver and drop down.
Repeat
Fan operation
Cool / Dry
operation
Fan operation
Cool / Dry
operation
Not
display
U
1,7
No.
1-1
U
1,7
No.
1-2
U
1,7
No.
1-3
U
1,7
No.
1-4
1
Unit select
button
As characteristics of air, cold air
accumulates lower area and warm air
accumulates upper area.
In Cool / Dry operation
Direct the louver (adjustment plate of up / down wind
direction) horizontally. If directing it downward, the dew
may form on the surface of the air discharge port and
may drop down.
In Fan operation
Select a desired wind direction.
Initial setup
Initial setup
1115653830_EN-TH.indd 10
1115653830_EN-TH.indd 10
7/14/2563 BE 10:14
7/14/2563 BE 10:14
