MASTERseries Release 6.01 - Quick Start Guide
9
Installation
Module Installation
Application Module Installation
- When installing
two
modules in a 2-slot chassis, install the first in slot 1 (first slot from the left).
- When only using
one
module, install it in slot 2. This is to ensure optimal cooling performance.
To install an application module:
1. Gently slide the module into the slot and press firmly to
make full contact with the midplane connector of the
chassis.
2. Be sure that the ID tag on the engine is to the
right
when
inserting into the chassis. The text along the edge
(
2 SLOT DOWN
) should be upright.
3. Secure the application module to the chassis with the
screws on the faceplate of the application module. When
correctly installed, the application module faceplate will
make contact with the chassis.
4. To install a second application module, repeat the process
for slot 2.
Removing an Application Module
To remove an application module from a 2-slot chassis, remove the two screws that lock the module
faceplate to the chassis, then push the ejector handle to the right to disengage the connectors. Slide
the module out carefully.
Adapter Installation
1. Insert the adapter module into the back of the 2-slot chassis (directly behind the application
module installed in steps above) and press firmly to make full contact with the midplane
connector of the chassis.
The text along the edge (
2 SLOT DOWN
) should be upright.
2. Secure the adapter module to the chassis, by tightening the screws on the faceplate.
NOTE:
Blank faceplates must be installed on each empty slot to be in compliance with
product emission standards.
