24
DISEqC troubleshooting table
Malfunction
Cause and remedial action
In menu option "DISEqC
monitor",
the display does not
change when the channel is
changed,
or
is displayed
The DISEqC function is not
activated at the receiver. Activate
the DISEqC function at the
receiver. (Refer to the manual of
your receiver.)
Within the menu option
"DISEqC monitor", the display
shows incorrect satellite position
numbers when the channel is
changed at the receiver.
In addition to standard DISEqC
functions, some receivers
facilitate extended special
functions. These must not be
activated.
In such cases it must be checked
whether your receiver is set to
DISEqC 1.0, 1.1 or 1.2.
Also, there are DISEqC 2.xx
signals that may be
misinterpreted by the CARO
system.
Check the settings at the satellite
receiver. Activate the
simplest
DISEqC function. (Refer to the
manual of your satellite receiver.)
In the menu option "DISEqC
monitor", the values are shown
correctly, but the system does
not respond to channel changes
at the satellite receiver.
Is the DISEqC function
activated at the CARO system?
(DISEqC: On)
Does the control panel display
show "Main menu" or
"Sat mode"?
If another menu option is active,
the DISEqC signals are ignored!
The system aims the antenna at
