P a g e |
87
EC declaration of conformity
Carlson declares that the FiX1 complies with the applicable standards and regulations.
for the full EC declaration of conformity.
Radio-frequency disturbance characteristics
As defined by
BS EN 55011:2016 Industrial, scientific and medical equipment – Radio-frequency disturbance
characteristics – Limits and methods of measurement
, the Carlson FiX1 is defined as Group 1, Class A equipment.
The Carlson FIX1 probe is suitable for use in all locations other than those allocated in residential environments
and those directly connected to a low-voltage power supply network which supplies buildings used for domestic
purposes. The Carlson FiX1 does not use radio- frequency energy for the treatment of material, for
inspection/analysis purposes, or for transfer of electromagnetic energy.
CAUTION: This equipment is not intended for use in residential environments and may not provide
adequate protection to radio reception in such environments.
FCC (USA only)
Information to the user (47CFR section 15.19)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
Information to the user (47CFR section 15.21)
The user is cautioned that any changes or modifications not expressly approved by Carlson or authorised
representative could void the user’s authority to operate the equipment.
Information to the user (47CFR section 15.105)
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
WEEE directive
The use of this symbol on Carlson products and/or accompanying documentation indicates that the product should
not be mixed with general household waste upon disposal. It is the responsibility of the end user to dispose of this
product at a designated collection point for waste electrical and electronic equipment (WEEE) to enable reuse or
Summary of Contents for FiX1
Page 2: ......
