CARLO GAVAZZI VMU-C EM, Instruction Manual

Page: 49 / 126

VMU-C
VMU-C Instruction manual 49
Once the procedure for the automatic detection of the connected devices is
completed, the system will display the page shown below listing the amount of the
devices detected for the COM1 port and for the COM Aux port of the VMU-C EM.
If all the devices connected to the ports (COM1 e COM Aux) have been detected,
you can stop the automatic scanning procedure through the “
Stop scanning
”
command.
VMU-C EM setting
If the scanning procedure has been successfully completed, save the resulting
information by pressing the “
Save Configuration
” button
VMU-C EM setting

Clicking on the “
Save Configuration
” item will grant access to the page shown
below
Clicking on the “
Manual setup
” item will grant access to the manual configuration
section shown below . From now on the configuration of the whole system will
start.
Note : the user will be able to ADD, MODIFY or REMOVE any VMU-M EM
devices even after they have been automatically detected.
Manual setup
Note : The LED on the left in figure 32 can take on 3 different colours, having the
following meanings:
- GREEN: configuration OK and serial communication enabled
- YELLOW: configuration OK but serial communication not enabled.
- RED: error in configuration data. Communication with the relevant module will
be impossible.