Spectra II Series
Maintenance and Cleaning
10.16
Betriebsanleitung
53
7.7 Replacing the Printhead (Flat Type)
B
D
E
C
F
A
A
G
I
I
H
H
G
Figure 16
1. Remove labels and transfer ribbon from the label printer.
2. When printhead is closed, loosen the screws (G).
3. Turn lever (F) counter clockwise to lift up the printhead (E).
4. If the printhead (E) is not disengaged on the pressure roller,
continue loosen the screws (G).
5. Remove the printhead carefully to the front until you can reach the
plug connections.
6. Remove plug connections and then remove printhead (E).
1. Attach plug connections.
2. Position printhead (E) in printhead mounting bracket in such a
way that the pin is secured in the corresponding hole in the head
plate.
3. Lightly keep printhead mounting bracket on the printer roller with
one finger and check for correct positioning of the printhead.
4. Tighten again screws (G).
5. Reload labels and transfer ribbon (see chapter 5 Loading Media,
page 27).
6. Check resistance value on the type plate of printhead and if
necessary change the value in the
Service functions/heater
resistance
.
Removing the
printhead
Installing the
printhead
