10
12.
Remove the rudder and align the control horn
on the mark you made. Make sure the holes
for the clevis are over the hinge line.
Mount the control horn using the 1.5mm
screws just as you did on the ailerons.
13.
Use the same method for the CA hinges on
the elevator and rudder that you did on the
ailerons. Hinge the elevator first then the rud-
der.
Mount the elevator control horn on the inner
portion of the elevator on the left side using
the 1.5mm screws.
MAIN GEAR & WHEEL INSTALLATION
1.
Collect the following items:
(2)
Landing gear wire
(4)
2 x 5/16"screw
(2
Landing gear strap
(3)
2-1/2" wheel
(4)
Wheel collar
(4)
Allen head set screw
3.
Insert the other gear leg in the hole on the
other side of the fuselage. One hole is at the
back of the slot and the other is at the front of
the slot. The two wires will lie next to each
other in the slot.
Use the two straps and four screws to retain
the gear.
4.
Install the wheels on the axles, as shown.
First the wheel collar goes on, followed by the
wheel, then the second wheel collar, and the
set screw. Tighten the set screw.
AXLE
WHEEL
SET SCREW
WHEEL COLLAR
WHEEL COLLAR
2.
Insert one gear leg in the hole in the bottom of
the fuselage.
