17
5
.
Tape the rudder so that it stays in the neutral
position.
Align the servo arm so that it is sitting at 90
degrees to the servo.
Mark the location where the pushrod wire
meets the outer hole of the servo arm.
6.
Bend the wire up 90 degrees at that mark.
Slide the swivel keeper over the end of the
pushrod and snap to the wire.
7.
Repeat steps 1 thru 4 for the elevator servo.
3
.
Bring the elevator pushrod out the right side
and the rudder pushrod out the left side.
4.
Put the clevis and the silicone keeper on the
pushrod end and connect to the control horn.
Repeat on the other side for the rudder.
8
Finished pushrods.
