12
ENGINE INSTALLATION
1.
C
OLLECT THE FOLLOWING PARTS
(1)
ENGINE
(4) #6
X
3/4
SHEET METAL SCREWS
(1)
MOTOR MOUNT PLATES
(1)
SPINNER
2.
Find the Motor mount plate and fit your
engine to it.
2.
Once you have your motor mount then place
the mount into the front of the fuselage.
Make sure that the smaller side beam is on
the left side of the fuselage.
The motor mount should point a little to the
right about 2 degrees. Mark the top of the
plate.
Left side of the fuselage
Gap
3.
Slide the engine into the motor mount and
through the front nose ring.
Open the spinner and place the spinner back
plate onto the engine. This will help to center
the front of the engine to the fuselage
Make sure that there is a clearance between
the spinner back plate and the front of the
fuselage .
8.
Install the rudder servo as shown.
Slide the nose gear wire into the hole in the
EZ connector.
Remount the servo arm and center the servo
arm and the nosegear wheel.
When satisified, tighten the set screw on the
EZ connector.
