4.
Make a 1/4” bend at the end of the throttle
pushrod and connect the push rod to the
throttle arm on the motor.
Slide a swivel keeper in place over the
pushrod and snap in place.
Move the throttle open and close to make
sure you have clearance. If you do not have
enough clearance then cut away some of the
fuselage sides to make enough clearance.
Hole
1.
C
OLLECT THE FOLLOWING PARTS
(1) 1.5
MM X
40
CM PUSHROD
(1)
NYLON TUBE
(1)
PUSHROD CONNECTOR
(1)
NYLON SWIVEL KEEPER
THROTTLE PUSH ROD INSTALLATION
2.
You will need to drill a hole for the throttle rod
through the number 2 and 3 bulkheads.
drill hole
5.
Install the throttle servo as shown.
Install the servo connector on the servo out-
put arm as you did for the rudder.
Adjust you throttle arm on the motor to open
and set your servo to fully open. Tighten the
screw on the servo connector.
10.
Remount the motor to the plate. If you wish to
have a break away motor mount you can use
four #6 X 3/4” sheet metal screws (not includ-
ed) and screw the plate to the beams, if not,
epoxy the plate in place.
3.
Slide the throttle pushrod tubing into the hole
in the firewall that you drilled earlier.
Push the tube through the fuel tank compart-
ment and through the small hole on the side
of the former.
14
