Carel pCO5+, User Manual

Page: 56 / 60

56
ENG
pC0300020EN rel. 1.2 - 07.11.2013
2. Confi rm by selecting Prg. A screen is displayed requesting
confi rmation to upload the non-volatile memory. Press Enter to
confi rm.
61-'*-&?%&7
Fig. 9.p
3. At the end a message will ask the user to remove the pendrive.
61-0"%*/('*-&
1-&"4&8"*5
Fig. 9.q
Upload in autorun mode
Uploading in autorun mode is a special case of uploading in automatic
mode. Unlike automatic mode, the user must wait for a specifi c message
to appear on the display to start or disable the operation described in the
confi guration fi le. To upload a fi le in autorun mode, a confi guration fi le
must be created and named “autorun.txt”.
Example of uploading BIOS+application. The upload involves two steps:
fi rst the BIOS is updated and then the application.
The information is shown on the pCO’s built-in display and on the pGD1
terminal, when both are featured.
Procedure:
1.
Connect the pendrive to port A.
U SB key
B M S card
Fig. 9.r
2. After a few seconds, Autorun mode starts. Press Enter to confi rm.
"65036/.0%&
61-0"%"11-*"5*0/
1RESS&/5&3TOSTART
&4$TOEXITAUTORUN
Fig. 9.s
3. The validity of the FW is checked and the BIOS is loaded.
'8VALIDATION
1LEASEWAIT
Fig. 9.t
4. The display fl ashes to indicate that after loading the new BIOS the
controller is being reset.
'8VALIDATION
1LEASEWAIT
Fig. 9.u
/0-*/,
p G D
Fig. 9.v
5. The test phase starts.
"PPLICATIONPROGRAM
CORRUPTEDORNOT
PRESENT
8"*5*/(FORUPGRADE
Fig. 9.w
/0-*/,
p G D
Fig. 9.x
6. The controller warns that no application has been loaded.
"PPLICATIONPROGRAM
CORRUPTEDORNOT
PRESENT
8"*5*/(FORUPGRADE
Fig. 9.y
/0-*/,
p G D
Fig. 9.z
7. The application update then starts.
6PLOADAPPL
1LEASEWAIT
Fig. 9.aa