20
docs.carbide3d.com
6.
Replace the M4 screws.
7.
Apply a small amount of Vactra No 2 along the ball screw and linear rail (approximately 1
–
2ml).
8.
Jog the axis the full length of travel a number of times at approximately 1000mm a min.
9.
Use a clean, lint-free cloth to wipe off any excess oil.
10.
Repeat steps 2
–
9 to lubricate each axis.
11.
Re-attach the two protective covers.
Replacing the Fuse
If the machine stops working suddenly, the fuse in the electronics cabinet may have blown. Contact the tech
support team at
for instructions for replacing the fuse.
Summary of Contents for Shapeoko HDM
Page 1: ...Shapeoko GETTING STARTED GUIDE HDM...
Page 2: ......
