CARBATEC.C OM.AU
WDS-4080P
MACHINE ADJUSTMENTS
1.
Using the height adjustment handle,
raise the sanding drum to its highest
position (roughly 3" above the
conveyor belt table)
2.
Using a phillips type screwdriver,
remove the 2 screws and star
washer securing the front nip guard
to the variable speed control box.
Then remove the front nip guard
by sliding it to the left and off the
outboard drive roller bushing.
3.
Using the supplied 6 mm hex wrench
key, remove both conveyor table
mounting bolts on the outboard,
open side of the wide drum sander.
Fig. M2
M.
REPLACING THE CONVEYOR BELT
Common causes which require replacement of the conveyor feed belt are:
• normal wear and tear,
• inadvertent contact with the sanding drum abrasive during operation,
• tears caused by mis-tracking of the conveyor feed belt,
• excessive build-up of non-removable film.
The following steps describe how to remove and replace the conveyor feed belt
when necessary:
Fig. M1
Fig. M2
CONVEYOR TABLE
MOUNTING BOLTS
6MM HEX WRENCH
FRONT NIP GUARD
23
