FOR TECHNICAL SUPPORT CALL
1800 658 111
WDS-4080P
ASSEMBLY
To keep freight costs to a minimum and reduce damage in transport, this wide
drum sander will require some assembly.
• The drum sander is not pre-assembled. After unpacking, the machine must
be installed prior to use.
• Transport the drum sander in its packing crate to a place near its final
installation site before unpacking it.
• If the packaging shows signs of possible transport damage, take the
necessary precautions not to damage the machine when unpacking.
• If any damage is discovered, the carrier and/or shipper must be notified of
this fact immediately to establish any claim which might arise.
F.
PLACEMENT LOCATION
Consider anticipated workpiece sizes and additional space needed for auxiliary
stands, work tables, or other machinery when establishing a location for this
machine in the shop. See dimensions on page 13, for reference.
G.
HEIGHT ADJUSTMENT
HANDLE ASSEMBLY
1.
Screw the height adjustment handle
into the threaded nut in the height
adjustment crank using a slotted
screwdriver until snug.
Fig. G1
2.
Locate the 4 mm set screw
threaded into the side of the height
adjustment crank. Position the
height adjustment crank over the
height adjustment shaft with the set
screw aligned with the machined flat
area on the height adjustment shaft.
Fig. G2
3.
Lower the height adjustment
handle assembly onto the height
adjustment shaft and tighten the set
Fig. G1
Fig. G2
HEIGHT
ADJUSTMENT
HANDLE
THREADED
NUT
HEIGHT
ADJUSTMENT
CRANK
HEIGHT ADJUSTMENT SHAFT
(WITH MACHINED FLAT)
16
