FOR TECHNICAL SUPPORT CALL
1800 658 111
WDS-4080P
J.
DRUM ALIGNMENT
Check the tightness of the elevation tension
adjustment screws. The tightness of these
screws must be adjusted to allow smooth
height adjustments, while ensuring a tight
enough fit to limit drum deflection. If the
screws are too loose, the drum will deflect
during use, causing an uneven sanding
surface. If the screws are too tight, sanding
drum height adjustment will be difficult.
To adjust the elevation tension adjustment
screws:
1.
Loosen the lock nuts, securing each
screw in place.
2.
Loosen or tighten each screw, as
required, in 1/4 turn increments
to attain the desired fit and
smoothness.
3.
Re-tighten the lock nuts to secure
the tension screws in position.
K.
TABLE ALIGNMENT
Check the sanding drum to conveyor table
alignment by first removing the abrasive
strip from the drum. The purpose of this
adjustment is to achieve equal distances at
point A and point B which will ensure that the
drum is parallel to the feed table and provide
uniform sanding.
Fig. K1
Fig. J1
Fig. J2
Fig. K1
ELEVATION TENSION
ADJUSTMENT SCREWS x 4
DRUM
CONVEYOR
TABLE
REFERENCE
(BLOCK OF WOOD
OR LEVEL)
NOTE: DRUM FRAME NOT DEPICTED FOR CLARITY
A
B
20
