
FOR TECHNICAL SUPPORT CALL
1800 658 111
WDS-4080P
1.
To tighten the tracking tension, the
tracking screw is rotated clockwise
while holding its nut in place with a
7/16 open end wrench (not supplied).
2.
To loosen the tracking tension,
the tracking screw is rotated
counterclockwise while the nut is
held with the wrench.
3.
If the conveyor feed belt is tracking
towards the inboard (motor side) of
the machine, tighten (add tension)
to the tracking adjustment screw on
that side of the machine.
Fig. L1
Fig. L2
OUTBOARD CONVEYOR FEED BELT
TRACKING ADJUSTMENT SCREW
INBOARD CONVEYOR FEED BELT
TRACKING ADJUSTMENT SCREW
MACHINE ADJUSTMENTS
NOTE: Due to the width of the conveyor feed belt, tracking adjustment may not
become apparent immediately! Increase the speed of the conveyor feed belt to
quicken the effects of your adjustments. Make small measured corrections of
approximately 1/4 turn increments and evaluate the results. Readjust as necessary
until the proper tracking solution is found.
L.
ADJUSTING THE CONVEYOR BELT TRACKING
AND TENSION
Occasional adjustment of the conveyor feed belt tracking may be required due
to belt stretching, normal wear and tear, and improper tensioning. Ideally, the
conveyor feed belt should track in the center area of the conveyor feed belt table.
Conveyor feed belt tracking adjustment screws are located on both the inboard
and outboard sides on the rear of the wide drum sander.
Fig. L1 & Fig. L2
22