Version 10.05.2012
USB-MK-CD
S
eit
e
9
3.3.3.
Radio module with Quadlock connector WITHOUT factory CD-changer
Installation is analogue to system with factory CD-changer. Only there is no female 12pin
connector on the vehicle harness. The male 12pin connector of harness C3C-BMW701 is not
used and should be isolated.
3.3.4.
Radio module with round-pin connector WITH factory CD-changer
Disconnect the audio cable
from harness C3C-BMW701
and remove pins from female
and male 12pin connector.
Loosen the female round-pin connector from the radio
module. Loosen the female 10pin CD-changer connector
of vehicle harness of the female round-pin connector.
Pin the female pins of the audio cable of harness
C3C-BMW701into the female 10pin CD-changer connector
and connect the corresponding female pins of the vehicle
harness to the male pins of the audio cable of harness
C3C-BMW701. Make sure to isolate all connections.
Use following assignments:
Interface Audio-cable
Pin to female
10pinconnector
Red
Pin 2
White
Pin 1
Black
Pin 6
Connect female 10pin CD-changer connector into female round-pin connector and female
round-pin connector back to the radio module.
CD-changer
Soundsystem
