Caple WC6217, Technical Information

Page: 21 / 28

15/23
→ Remove the display supporter → Remove the middle electrical box → Remove the
screws → Remove the upper and lower air-duct board. → Remove the inner air-duct board
→ Remove the heater fixing screws → Remove the heater
After removing the air-duct board, the heater is on the back of it, remove the fixing
screws and we can remove the heater.
（ Fig.10 ）
6.1.7. How to remove the defrost sensor and upper compartment sensor.
The process: Remove the shelves → Remove the control panel film → Remove the screws
→ Remove the display supporter → Remove the middle electrical box → Remove the upper
air-duct board → remove the sensor cover → remove the sensor
1. Remove the upper air-duct board(A), pull out the two expanding nails(D), the sensor
cover(C) loose, pull out the sensor (B).
(Fig.11)
2.The process: Remove the shelves → Remove the lower air-duct board → remove the
sensor
Remove the shelves, remove the lower air-duct board, we can see the lower compartment sensor,
remove the sensor fixing screw and remove the sensor
(Fig.7)
6.1.8 ． How to remove the LED light.
1. How to remove the lower compartment LED light.
The process: Remove the shelves → Remove the control panel film → Remove the screws
→ Remove the display supporter → Remove the PCB
①
.Remove the shelves, peel off the control panel film, remove the middle electrical box.
( Fig.2& Fig.3 &Fig.4)
②．
Disconnect the connector, press the head of the nails one by one, pull the light PCB
Screws
Heater
Back of the
inner air-duct
board
Fig.10
Fig.11