Caple WC6217, Technical Information

Page: 24 / 28

18/23
Diagram of main PCB connection. ( Fig.16)
14
15
16
1. Defrost sensor (T3) 2. Lower compartment sensor (T2) 3. Upper compartment sensor (T1)
4. Door switch 5. Transformer secondary 6. Compressor
7. Power - N 8. Transformer primary
–
N 9. Transformer - L 10. Power - L
11. PTC heater 12. Outer fan (RED) 13. Display PCB 14. Upper fan (F1)
15. Lower fan (F2) 16. Heater fan(F3) 17. LED light (WHITE)
6.2.3 ． How to remove the compressor
The process of removing the compressor: Remove the electrical cover of compressor →
disconnect the connectors → separate the pipe connect to the compressor → remove the
compressor
Heat E, F with s
oldering iron
, and disconnect the pipes by using the plier. Remove the
electrical cover of the compressor, and then remove four compressor fixing screws, remove
the compressor.
(Fig.17)
Diagram of rear soldering joints (Fig.17)
A: Jointing pipe and condenser joint B: Process pipe joint C: Electrical cover of compressor
D: Compressor E: Suction pipe joint F: Discharge pipe joint G: Capillary joint
H: condenser and filter joint I: Outer water tank support J
：
Four condenser fixing screws
K: Condenser
Fig.16