28
CH
quadrant below axle, lines led to
blocks on plate bolted to back of steering disk
(CS36)
(Seen from above) Axle offset to
locate
CH
quadrant in front of rudder
stock ; control lines led to block on
tiller (which has
been
extended) to which
hydraulic ram is connected. (CT 37)
Jamming Cleats
The jamming cleats should be located within
easy reach of the wheel. Whenever possible, they
should, placed side by side, which allows tying the
two lines in a knot when the rudder is amidships and
quadrant and pendulum are vertical, and to find this
position automatically by pulling the two lines
together. (If the cleats can not be located together,
the lines should be marked to locate the position
rudder amidships and pendulum-quadrant vertical.)
If the jamming cleats are located above the
holes (instead of below), the lines can be pulled and
cleated in one single movement.
