Cansec MAP2, Installation Manual

Page: 8 / 32

MAP2 Page 8 of 32
Installation Manual September 2020 • Rev. 1.5
Important Installation Notes
Controller Provisioning Options:
The MAP2 controller is provisioned with the default 2-door configuration. However,
the door configuration can be upgraded. The MAP2 can run only in one mode either
First Access or CloudACS . Door configurations are as follow:
a. 2–door configuration: 2 lock relays, 2 multi-function relays, 2 REX/RTE, 2
door contacts/DPS, 12 general-purpose
input points and 12 general-purpose
output points.
b. 4–door configuration: 4 lock relays, 4 multi-function relays, 4 REX/RTE, 4
door contacts/DPS, 8 general-purpose
input points and 8 general-purpose
output points.
c. 6– door configuration: 6 lock relays, 6 multi-function relays, 6 REX/RET, 6
door contacts/DPS, 2 general-purpose
input points and 2 general-purpose
output points.
d. 8–door configuration: 8 lock relays, 8 multi-fucntion relays, 8 REX/RET, 8
door contacts/DPS, 0 general-purpose
input point and 0 general-purpose
output point.
Elevator Configuration : See MAP2 Elevator Controller Installation Guide
Electrical Information:
1. The MAP2 utilizes a mini-computer and must be operated using a battery
backed up power supply to protect the hardware, system files and data files
from corruption due to power outage. See Note 1 in Appendix section.
2. CAUTION : Do not unplug the
MAP2 Power connector if the
system is in operation as data
corruption may occur on the
MAP2 mini-computer. Please
follow the instructions from the
section “
Shutdown Button ”.
Figure 2