Cansec MAP2, Installation Manual

Page: 24 / 32

MAP2 Page 24 of 32
Installation Manual September 2020 • Rev. 1.5
3. When the controller emits a long-loud beep, set dipswitch #4 to OFF (slide to
the left) to reboot the controller automatically. This will take another 20 to 45
seconds after which the controller will reset all of its configurations, including
the password (default is Cansec), to factory default with DHCP enabled.
Existing
database containging cardholders, schedules etc… will not be reset or erased .
Note : The end of the process is indicated by a MAP2 turning back on the associated
system LEDs with STAT LED flashing green along with a short series of beeps (1 or 3
beeps) to indicate its respective provisioned mode
First Access
or
CloudACS
4. Plug the MAP2 to the network with a DHCP server available.
5. Install and launch IP Configuration Tool from your computer. This tool is
available from the First Access software installation package, but is also available
as its own separate installation package which can be downloaded from
www.cansec.com/downloads.
6. In most cases, the IP Configuration Tool will detect and display the default IP
address range ready to be scanned. However, the IP address range can be
manually modified accordingly.
7. Click Scan to scan the network for all possible connected MAP2 panels.
Figure 18
Figure 19
Skip step 5 to 11 if static IP
address is not required.