Canon SX50 - REALiS SXGA+ LCOS Projector, Command Reference Manual, Page: 27 / 66

e
Commands
SEL Mode Control Setting
Referenc
Function Input signal selection
Parameter
ID
Parameter Meaning
AUTO Auto
Response
An 'i:OK' is returned after setting is successful.
Description This selects the input signal.
(1) In this command, only “Auto” is enabled.
(2) This command is identical to the Auto function under the Input signal settings in the Display settings
menu.
(3) The GET command can be used to retrieve the current input signal.
Parameters Remarks
PAL Includes PAL-M and PAL-N
SECAM
NTSC Includes NTSC4.43
1080i
Includes 540p (1080i non-interlaced signal)
1035i
720p
575p
480p
575i
Includes 288p (PAL non-interlaced signal)
480i Includes 240p (NTSC non-interlaced signal)
UNKNOWN No-color, 1080p, and other signals
Example Setting
> SEL=AUTO This sets the input signal selection to “AUTO”.
< i:OK
Reference
> GET SEL or ?SEL This retrieves the input signal.
< g:SEL=575p
*Commands are indicated by “>”, and responses are indicated by “<”.
Supported Command States
Power supply
Input Mode
OFF ON PM
D-RGB A-RGB1 A-RGB2 Comp Video S-Video None Remote Local
× ○ × × × × ○ ○ ○ × ○ ×
※
If a state is not supported, “INVALID_MODE”, “NOT_POWER_SUPPLIED” or “INVALID_SOURCE” is returned with the Err response.
※ If the required signal input is not available, an 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
※ When the power supply state is in the process of switching, an “i:BUSY” reply may be sent.