Canon Super G3 FAX Board-AP1, Service Manual

Page: 58 / 58

6
6
Installation
Installation
6-8
6-8
Installation > Operation Setting
Installation > Operation Setting
Operation Setting
■ Type Setting
Select the country/region of the FAX Board in Service Mode: FAX > type > TYPE
This setting performs the parameter settings to match the communication specification of
country/region.
1) Set the TYPE of country/region to install this equipment, and then press OK.
Service Mode> FAX > type > TYPE
2) Confirm that service mode parameter below is [0].
If the parameter is [1], change it to [0].
COPIER > OPTION > DSPLY-SW > SDTM-DSP
NOTE:
To change the above parameter to [0] makes the following menu indication
extinguished and auto-shut down function disabled.
[Settings/Registration]
3) Turn OFF/ON the main power switch to enable the above setting.
■ Basic Setting
NOTE:
When "System Manager Information Settings" is configured, be sure to follow the
direction of user administrator in order to log in as an administrator.
In this section, procedures for only minimum settings required for FAX communication are
described.
1) Set the user telephone number.
[Settings/Registration]> [Function Settings]> [Send]> [Fax Settings]> [Set Line]> [Line 1]>
[Register User Telephone No.]> Enter FAX number> [OK]
2) Set the type of telephone line.
[Settings/Registration]> [Function Settings]> [Send]> [Fax Settings]> [Set Line]> [Line 1]>
[Select Line Type]> Select the line type to connect> [OK]
3) Turn OFF/ON the main power switch.
■ Fax communication test
Perform the communication test to check if the fax function works properly.
1) Switch the screen to the Send/Fax screen.
2) Send a test original from the remote unit for a communication test to the equipment and
check if it can be received correctly.
• Press [Status Monitor/Cancel] > [Send] > [Log] and select [Fax] from pull down menu.
• Press [Print List] > [Print the fax activity report?] > [Yes].
• The number printed following colon(:) in "COMM. MODE" field on Fax Activity Report TX/
RX shows line type used for sending/receiving.
E.g. "ECM:1" => Line 1
3) Send a test original from the equipment to a remote unit with which a communication test
can be performed and check if it can be sent correctly.